![background image](http://html1.mh-extra.com/html/navitar/colorpro/colorpro_user-manual_3603824014.webp)
Installing a
New Lamp
If you have any questions regarding the installation of the
Xenon lamp, please call Navitar at 1-800-828-6778 or
716-359-4000.
Make sure the projector is unplugged and the bulb is
thorougly cooled before proceding.
Do not open the side cover while the lamp is lit.
A Phillips screwdriver is required. Remove the side panel
(one screw) and the bulb cover (two screws). Then
remove the rear panel (two screws) and unscrew the
positive lead screw on the side of the lamp. Unscrew the
black end cap and remove the bulb by holding the metal
tip.
Hold the bulb by the metal end and place it into the
reflector. Make sure that the pointed section of the bulb is
facing downward at 6 o’clock.
Now, replace the black end cap and reconnect the positive
lead wire to the side of the lamp housing using the screw
you removed earlier. Reattach the bulb cover to the lamp
housing and attach the side panel. Then, reattach the
rear panel.
If the bulb needs to be aligned, remove the back cover and
adjust the three screws on the rear panel.
Lamp Installation
Removing
the Lamp
13