User’s manual NAVIGON Primo
- 14 -
Switching on the NAVIGON Primo
►
the unit of length for distances
►
the time format
Note:
When you start the navigation application for the first time, the
D
EMO
M
ODE
settings window opens.
Demo mode is intended only for demonstrating the product when no
GPS reception is possible.
When demo mode is active, navigation is not possible! Demo mode
is designed solely to simulate navigation to the centre of the
indicated destination.
►
Make sure that the Start in Demo Mode setting is at No. If
necessary tap on the
(Toggle), button in order to change
the setting from Yes to No.
►
Tap on OK.
Note:
How to deactivate demo mode is explained in "Troubleshooting"
in section "I have accidentally activated demo mode" on page 65.
Note:
If you have not used the
NAVIGON Primo
for a long time, the
battery may be flat.
When you connect the navigation device to the supplied car charger
cable, it can be switched on immediately even if the battery is flat. If you
use a different charger cable or have connected your device to a PC, it
may need charging for approx. 3 minutes before it can be switched on.
Chargers and other accessories are available in the NAVIGON online
shop at
www.navigon.com
or in specialist stores.
Switching the navigation device to standby mode
►
Press briefly on the
(
On/Off
) key (max. 2 seconds).
Automatic Standby
You can configure the
NAVIGON Primo
so that the navigation device is
automatically switched to standby mode when not in use.
►
In the
N
AVIGATION
window tap on Options > Settings > General >
Automatic Standby.
►
Select after how much time you want the navigation device to be
switched to standby mode (Never, After 10 mins, After 20 mins,
After 30 mins).
►
Select Power Loss in order to switch the device to standby mode
when the external power supply is interrupted. As soon as the
device is connected again to the external power supply it will switch
on again automatically.