User’s manual NAVIGON 14xx | 24xx
Switching on the NAVIGON 14xx | 24xx
- 13 -
Data from at least three satellites is required for positioning with an
acceptable degree of accuracy. With data from four or more satellites it
is possible in addition to determine the position's altitude above sea
level. Positioning is accurate to within three metres.
Once the navigation device has determined your position, this position
can be used as a starting point for calculating a route.
The map data on your navigation device includes the geographical
coordinates of all digitally recorded points of interest, streets and
places. This enables the device to calculate a route between a starting
point and a destination.
Calculation of the current position and its representation on the map
take place approximately once every second. In other words, your
current position is always shown on the map.
3
Switching on the NAVIGON 14xx | 24xx
►
Press the
(
On/Off
) key and keep it pressed until the device
switches on.
The
N
AVIGATION
window opens.
Note:
The display lights up briefly in white, indicating that you have
started the device.
When you switch on the
NAVIGON 14xx | 24xx
for the first time, you
will be asked to make the following settings:
►
your preferred language for using for the software
►
the unit of length for distances
►
the time format
Note:
When you start the navigation application for the first time, the
D
EMO
M
ODE
settings window opens.
Demo mode is intended only for demonstrating the product when no
GPS reception is possible.
When demo mode is active, navigation is not possible! Demo mode
is designed solely to simulate navigation to the centre of the
indicated destination.
►
Make sure that the Start in Demo Mode setting is at No. If
necessary tap on the
(Toggle), button in order to change
the setting from Yes to No.
►
Tap on OK.
