Navien LCB700-21RS, Installation & Operation Manual

Page: 57 / 96

Operating the Boiler 57
Item Description
6. Burner Temp Burner housing sensor temperature (°C)
7. Outdoor Temp Outdoor temperature (°C)
8. Water Press Water pressure (bar)
8. Inlet Temp Inlet temperature(°C)
9. DHW Temp DHW temperature(°C)
10. Outlet2 Temp DHW outlet2 temperature(°C)
11. Tank Temp DHW pre-heat tank temperature(°C)
12. Water Press Water pressure (bar)
13. Flame Value
Flame detector AD value
Ɣ
Flame On: 8bit AD values equal to or
lower than 70
Ɣ
Flame Off: 8bit AD values equal to
or higher than 175
14. Fan Target RPM Set the fan speed (RPM)
15. Fan Current RPM Current fan speed (RPM)
16. Fan Target APS
Ɣ
Set APS voltage (V)
17. Fan Current APS Set the oil pump speed (RPM)
18. Oil Pump Target
RPM
Current oil pump speed (RPM)
19. Oil Pump Current
RPM
Oil Pump speed(RPM)
20. Exhaust Temp Exhaust temperature (°C)
21. OTC ON/OFF OTC Status (Enable/Disable)
22. K-Factor K-Factor for the OTC
23. Model Model type
24. Type Boiler type
25. Oil Oil type
26. Main F/W ver Main firmware version
27. Panel F/W Ver Panel firmware version
Note
The fan motor controls APS, so the Fan Target RPM is
only for your reference.
System/Regular Models
Item Description
1. Operation State Current Operation State
2. Heat Capacity Heat capacity (Low or High)
3. CH Set Temp Central heating set temperature (°C)
4. DHW Set Temp
DHW indirect supply set
temperature (°C)
5. Supply Temp Heating supply temperature (°C)
6. Burner Temp Burner housing sensor temperature (°C)
7. Outdoor Temp Outdoor temperature (°C)
8. Water Press Water pressure (bar)
9. Flame Value
Flame detector AD value
Ɣ
Flame On: 8bit AD values equal to or
lower than 70
Ɣ
Flame Off: 8bit AD values equal to
or higher than 175
10. Fan Target RPM Set the fan speed (RPM)
11. Fan Current RPM Current fan speed (RPM)
12. Fan Target APS
Ɣ
Set APS voltage (V)
13. Fan Current APS Set the oil pump speed (RPM)
14. Oil Pump Target
RPM
Current oil pump speed (RPM)
15. Oil Pump Current
RPM
Oil Pump speed(RPM)
16. Exhaust Temp Exhaust temperature (°C)
17. OTC ON/OFF OTC Status (Enable/Disable)
18. K-Factor K-Factor for the OTC
19. Model Model type
20. Type Boiler type
21. Oil Oil type
22. Main F/W ver Main firmware version
23. Panel F/W Ver Panel firmware version
Combi Models
Item Description
1. Operation State Current Operation State
2. Heat Capacity Heat capacity (Low or High)
3. CH Set Temp Central heating set temperature (°C)
4. DHW Set Temp DHW set temperature(°C)
5. Supply Temp Heating supply temperature (°C)