BHM
11/18/14
NTV-DOC117
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
7 |
P a g e
1.
RADIO TYPE:
Used to accommodate the different configurations of stock GM radios.
CADILLAC: Select this when vehicle is a Cadillac.
CHEVROLET: Select this when vehicle is a Chevrolet.
GMC: Select this when vehicle is a GMC.
NOTE 2:
When either Chevrolet or GMC is selected, turning VIM ON also
enables the Control in Motion features. However, when Control in
Motion is turned on,
VIM is not enabled.
2.
VIM DEFAULT:
Stores the default setting for Video In Motion.
ON: VIM is Always ON until the user turns it off.
OFF: VIM is Always OFF until the user turns it on
. (Recommended)
LAST STATE: Instructs the module to store the last state VIM was
set when the car was turned off.
NOTE 3:
To enable VIM in Chevrolet or GMC vehicles select “ANT.
INTERRUPT” for the programmable Output A or B, connected to the external antenna relay
board.
3.
BEEP:
Enables or disables the audible tones the Barracuda uses to
signal the user a state has changed.
ON: Audible beeps, generated by the Barracuda, are ON.
OFF: Audible beeps, generated by the Barracuda, are OFF.
4.
CIM TIMEOUT:
Sets the amount of time that CIM stays active after
being turned on.
1 MIN: Control in Motion is enabled for 1 Minute.
5 MIN: Control in Motion is enabled for 5 Minutes.
Programming continues on next page…
