background image

BHM 

11/18/14 

NTV-DOC117  

 

 

 

Agreement

End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for 

misuse of its product.  If you do not agree, please discontinue use immediately and return product to place of purchase. This product is 
intended for off-road use and passenger entertainment only.  

10 | 

P a g e

 

 

Barracuda Operation 

 

 
All Functions of the Barracuda are controlled 

through the vehicle’s power mirror direction pad. The 
Barracuda controls are only available when the left and 
right mirror buttons are NOT selected (LEDs OFF). 
Example: if the Left Mirror button is illuminated, press the 
illuminated Left Mirror button again to turn the LED off. 

 
 
 

 

 

Video In Motion:

 Momentarily pressing the left arrow will 

enable/disable video in motion. This function will allow the user to 
view DVD video or AUX video (if available) while the vehicle is in 
motion.  

 

 

Control In Motion:

 Momentarily pressing right arrow will 

enable/disable Control in motion. Control in Motion allows the user 
to access radio functions that are normally blocked while the vehicle 
is moving. 

Note:

 When activated, Control in Motion (CIM) will remain ON for 1 

or 5 minutes (user selectable) and then deactivate itself. 

 

Forced Rear Camera:

 Momentarily pressing down arrow 

enables/disables forced rear camera (if applicable). This will allow 
the user to view the back-up camera video regardless of speed or 
gear. 

*Requires Factory Rear Camera, Dealer programming of Radio for Rear Camera, 
OR NAV-TV GMLANCAM module for compatible radios. See Glove Compartment 
for a silver sticker with one of the following markings UV8, UV9, UVA, or UVB to 

determine radio compatibility. 

 

Front Camera:

 Momentarily pressing up arrow enables/disables 

front camera (if applicable). This will allow the user to view the 
front camera video regardless of speed or gear. 

*Requires Factory Rear Camera, Dealer programming of Radio for Rear Camera, 
OR NAV-TV GMLANCAM module for compatible radios. See Glove Compartment 
for a silver sticker with one of the following markings UV8, UV9, UVA, or UVB to 
determine radio compatibility. 

 

Summary of Contents for Barracuda












Reviews: