![background image](http://html1.mh-extra.com/html/nautilus/sport-series/sport-series_assembly-manual_3545733014.webp)
0
AssEMBLy guiDE
bASe ASSembly guide
step 2: Tightening Motor pan Bolts
Locate the following for this step:
Parts:
• assembly from step 1
tools:
• 1/2 inch socket with ratchet (not provided)
2-1 tighten the factory installed motor pan bolts
before proceeding with assembly.
Figure 2: step 2 Tightening Motor pan Bolts
Motor pan Bolts
Base Assembly
Motor pan Bolts
step 1: Continued
NOtE: You may need to loosen the motor pan bolts
(see step 2 for location) and move the front
cross support bracket towards the front of
the base assembly for the Upright supports
to fully fit onto the brackets.
1-3 Verify that the wiring harness connectors are
accessible at the top and bottom of the right
Upright assembly.
1-4 Install right Upright assembly onto Base assembly
using 2 of the 5/16 - #18 x 1-1/2 hex head bolts and
2 flat washers on the front side of the assembly
and 1 hex head bolt (5/16 - #18 x 2) on the outside of
the assembly.
hand Tighten Bolts only.