Nautilus Be Strong Commerical T912, Service Manual

Page: 55 / 130

55
Nautilus® Commercial T9 Series Treadmill Service Manual
Table 4–3. Error List
Display Type Response Description
TM HW COM
ERROR
Error Anytime—Goes to idle. Treadmill
slowly stops.
Treadmill UART hardware link failure.
TM COM ERROR Error Anytime—Goes to idle. Treadmill
slowly stops.
Treadmill drive communication failure.
DRIVE ERROR Error Program operation—Goes to idle.
Treadmill stops quickly.
Treadmill drive (VSD) failure, possible
output switching fault recycle power
and determine if failure is intermittent.
OUT CUR ERROR Error Program operation—Goes to idle.
Treadmill slowly stops.
Treadmill output current too low.
BELT OVRLD
ERROR
Warning During movement—Displays
message until the user presses
CLEAR .
Treadmill moderate drive overload.
Designed to inform the user that the
belt or deck will need to be replaced
soon.
SYS OVRLD
ERROR
Error Program operation—Goes to idle.
Treadmill slowly stops.
Treadmill high drive overload.
DRV MON ERROR Error Program operation—Goes to idle.
Treadmill slowly stops.
Treadmill current monitoring circuit
failure.
CONFIG RQRD Error Start-up—Stops operation. Treadmill configuration not allowed
or device needs to be configured.
GRD LIMIT
ERROR
Error During change—Goes to idle.
Treadmill slowly stops.
Treadmill grade position outside
limits.
GRD MOVE
ERROR
Error During change—Goes to idle.
Treadmill slowly stops.
Treadmill grade system detected an
non-requested response.
SPD CHANGE
ERROR
Error Program operation—Goes to idle.
Treadmill slowly stops.
TM drive is commanded to change
speed but doesn’t.
STUCK KEY Error Start-up—Stops operation. One of the keypad keys are stuck in
an active state. Reports only “Stuck
key.”
Table 4–4. Production Test Errors (requires special equipment to test console, see
factory)
Display Type Response Description
CS HW COM
ERROR
Warning Start-up—Stops CSAFE but
continues user selection.
ALL—CSAFE UART hardware link
failure.
CS COM ERROR Warning Anytime—Stops CSAFE but
continues program.
ALL—CSAFE communication failure.
SECTION 4: T914/916 TROUBLESHOOTING ELECTRICAL PROBLEMS