Step 1:
Locate the following for this step:
Parts:
s
Console Mast (B)
s
Seat Assembly (D)
Hardware:
s
Ref #1 Allen Head Bolt M10x25 Qty. 4
s
Ref #2
Spring Washer
M10
Qty. 4
s
Ref #3 Flat Washer M10 Qty. 4
Tools:
s
8mm Allen Wrench
1-1 Connect the attached long Wire Tie (L) to the
main and TV cables (M) and use it to pull the
cables up through the Mast (B). Keep the wire to
attach the cable again.
1-2 Align the Mast (B) with the four holes in the Main
Frame. (N)
1-3 Install and hand tighten the hardware.
1-4 Insert the Seat Assembly into the Main Frame.
Pull up on the Adjustment Lever (J) to allow the
locking pin to to clear the Main Frame and
release the Adjustment Lever when the seat is
at the desired height.
*Note:
Make sure that the plastic seat sliders inside
the seat tube are in the correct position to
prevent any damage. If the seat slider plastic
tabs have fallen out of slots at the bottom of
the seat post, carefully push the seat slider
plastic back into holes prior to seat
installation.
The following instructions provide direction in assembling the base unit for the Nautilus® Commercial Series Bike model
U916. All instructions in the manual are given with the orientation of sitting on the bike facing the console. The console is
the front, while the seat is the back.
ASSEMBLY GUIDE
Figure 1:
B
L
M
N
1
2
3
D
J
8
Summary of Contents for Be Strong Commercial Series U916
Page 1: ...Be Strong 003 3376 060309A Rework Manual Commercial Series Bike U916 ...
Page 25: ...Place mast in carton Remove seat from bike Get 000 4897 bag and place over seat assembly 25 ...
Page 31: ...Band box shut on both ends Place bands where the upright supports are in box 31 ...
Page 33: ...The Multi Build FISP Load screen should look something like this OR 33 ...
