If the LED turns RED, it indicates a failed program sequence. If
this happens, try the above process again.
ing cable
from the console/controller. Power does not need to be turned off prior to removing the cable.
. The C5X console/controller should display the machine configuration, status, and then the startup screen.
B.
he console/controller for the correct exercise device, and verify that the software has been
upgraded:
Non-treadmill machines:
5. Wait for the F.I.S.P. LED to turn GREEN.
6. Once the programming is complete, the green LED will turn on. Remove the F.I.S.P. programm
7
Configure t
TER], on the C5X console. The console will display “CHANGE MACHINE.” Press
[ENTER] again.
2. Press [^] until “BIKE,” Rev B shows on the display. Press [ENTER] to select that machine type.
4] [ENTER] then [INC or DEC] on
the C5X console. The console will display “CONS 4137X-0XX.”
1. Press [^], [8], [EN
3. Verify that the correct software version is in the console. Press [^] [
13
Summary of Contents for Be Strong Commercial Series U916
Page 1: ...Be Strong 003 3376 060309A Rework Manual Commercial Series Bike U916 ...
Page 25: ...Place mast in carton Remove seat from bike Get 000 4897 bag and place over seat assembly 25 ...
Page 31: ...Band box shut on both ends Place bands where the upright supports are in box 31 ...
Page 33: ...The Multi Build FISP Load screen should look something like this OR 33 ...
