10
1.
Install the CR2032 battery provided
into the battery compartment on
the circuit board inside the front
part of the housing.
5.
Setting up the moisture alarm:
2.
Switch the alarm on. The LED light will
flash blue once and turn blue for five
seconds indicating the battery is
normal. Then it goes into flashing blue
light standby mode.
3.
Test the alarm by connecting the two
wires near the bottom of the housing
with a damp cotton bud; the alarm
should start giving out a repeating
“beep” sound along with a flashing red
light. The “beep” sound and the light
should keep on going for 5 seconds
after the removal of the damp cotton
bud .
