Nautel VS1, Installation Manual, Page: 20 / 54

VS1 Installation Manual Mounting the transmitter
Page 2-2 Issue 2.0 2010-12-01
Figure 2.2: Installing sliders and transmitter in cabinet
4. Install the assembled cabinet sliders in the desired position (see Figure 2.2 ). Adjust the
cabinet slider depth as required to fit the cabinet. For each cabinet slider, use two M5
countersunk screws (Nautel Part # HMSF32) on the rear bracket and two on the front
bracket. When securing the front bracket to the cabinet angle, use the inner two holes,
leaving the top and bottom holes open. When complete, tighten the hardware that was left
loose in
Step 3 .
5. Use six 10 mm long M4 screws (Nautel Part # HMSP20; three per side) to install the
transmitter mounts to the sides of the VS1 (see Figure 2.2 ). ( DO NOT use any hardware
under the screw head).
6. Slide the VS1 into the cabinet until the VS1’s front panel is flush with the cabinet’s front
mounting edges. Secure the front panel to the cabinet using four M5 panel screws (Nautel
Part # HMSF50) and four finishing washers (Nautel Part # HU36).
CABINET SLIDERS
(install on each
side of cabinet)
TRANSMITTER MOUNT
(install on each side of transmitter;
3 M4 screws per side)
USER-PROVIDED
CABINET
VS1