Nautel NX50, Operation And Maintenance Manual, Page: 160 / 166

NX50 Operations and Maintenance Manual Non-standard maintenance
Page 4-4 Issue 3.3 2016-02-08
4. This completes the software upgrade. Restore the former network settings on the transmitter
and laptop as required (see Step 2 of “Transmitter IP Configuration” on page 4-2 ).
5. Login and repeat Step 1 of “Preliminary Checks” on page 4-1 to determine if the current
version is the same as the upgrade version - this confirms the upgrade was successful.
6. If the upgrade was not successful, repeat Step 1 through Step 5 . If still unsuccessful, contact
Nautel.
Touchscreen Calibration
A touchscreen calibration will be required if the AUI or the compact flash card has been replaced. To
perform a touchscreen calibration, perform the following steps:
1. Connect a USB mouse into the single board computer (SBC) on the back of the control
cabinet’s front door
2. Set the transmitter for
Local
control.
3. Using the mouse, select
Menu
to display the
Main Menu
options. Select
System Settings,
then
Screen Configuration
.
4. From the
Screen Configuration
page (see Figure 4.1 on page 4-5 ), click the
Touchscreen
Calibration
button.
5. Follow the on-screen prompts to calibrate the touchscreen by pressing on the X’s where
instructed to do so.
NOTE! Make sure to clear the cache of every web browser used to
remotely connect to the transmitter's AUI to ensure that the remote
AUI displays correctly after the software upgrade.
NOTE! The Screen Configuration menu is only visible in Local mode.