Dual ND500II (User Supplied Cabinet) – IS03003
Page 3
Information Sheet
Issue 1.0
(e)
Install the cable harness (Nautel Part
# 158-8202) into the cabinet as
follows:
-
Remove transmitter (A and B) rear
covers. Retain hardware to re-install
cover.
-
Terminate the connectors on
transmitter A as follows:
Connect BNC connector P5 to A11J3
Connect D connector P6 to A11J4
Connect N connector P7 to A7J3
Connect wire # 45 to A11TB2-1
Connect wire # 46 to A11TB2-2
-
Make the following connections if the
cabinet’s output connector is located
near cabinet lower right hand side:
Connect P10 to A7J2
Connect wire # 44 (core) to cabinet’s
RF output connector (center
conductor)
Connect wire # 44 (shield) to cabinet’s
RF output connector (shield)
If cabinet’s output connector is not
located near the cabinet’s lower right
hand side, do not terminate P10 or
wire # 44. Secure these wire ends to
the cable harness.
-
Terminate the connectors on
transmitter B as follows:
Connect D connector P8 to A11J4
Connect BNC connector P9 to A11J3
Connect N connector P11 to A7J2
Connect wire # 47 to A11TB2-1
Connect wire # 48 to A11TB2-2
-
Terminate the connectors on dual
transmitter interface assembly as
follows:
Connect D connector P3 to A1J5
Connect D connector P2 to A1J4
Connect BNC connector P1 to A1J7
Connect BNC connector P4 to A1J6
Connect wire # 45 to A1TB4-3
Connect wire # 46 to A1TB4-4
Connect wire # 47 to A1TB4-3
Connect wire # 48 to A1TB4-4
-
Secure the cableform to the cabinet to
ensure the transmitters can be pulled
out on their slides and no wiring in the
cable can be pinched.
(f)
If the computer remote control option
is installed, install cable harness
Nautel Part # 158-8212 as follows:
-
Terminate the connectors on the
remote control assembly as follows:
Connect D connector P13 to A1J4
Connect wire 101 to TB1-1
Connect wire 103 to TB1-2
-
Terminate the connectors on the dual
transmitter interface assembly as
follows:
Connect D connector P12 to A1J1
(g)
Install the dual transmitter interface
assembly in the cabinet using the four
front panel mounting holes.
(h)
Install the remote control unit in the
cabinet using the four front panel
mounting holes.
(i)
Install the safety ground wiring using
green/yellow wire and lugs provided in
‘Safety Ground Wire Kit’ (Nautel Part #
158-8226) as follows:
-
Transmitter A safety ground (located
at rear of transmitter) to cabinet safety
ground.
-
Transmitter B safety ground (located
at rear of transmitter) to cabinet safety
ground.
NOTE
A cabinet safety ground should be located
near the RF output connector of the cabinet
to help protect equipment from lightning
damage.
(j)
Connect AC line cords to transmitter A
and B. Termination is made at
transmitter rear.
