Nautel GV10, Installation Manual

Page: 17 / 62

GV10/GV7.5 INSTALLATION MANUAL INSTALLING OPTIONS
VERSION 3.0 2014-11-01 PAGE 2.3.1
SECTION 2.3: INSTALLING OPTIONS
The GV10/GV7.5 transmitter is factory configu
r
ed and
shipped to operate with the customer’s desired ac
power source voltage and RF output connector size.
There are options available for various other features, including dual exciter, internal audio processor
and UPS interface. These options may be installed in one of two ways:
 You install and configure options at your site, using kits and instructions provided by Nautel. Each
option has a separate kit.
 Pre-arrange for Nautel to install and configure options at the factory prior to shipping.
Table 2.3.1 shows the factory configuration of the GV10/GV7.5, as well as the available options. Each
option references a recommended schedule of installation and the procedure (or associated document)
that describes how to install and configure the option.
Review the options in Table 2.3.1 to determine which, if any, apply to your installation.
If you did not purchase any options for your GV10/GV7.5 and intend to operate with the standard
(default) configuration, proceed to
Section 2.4, “Connecting to Station Reference Ground” .
Table 2.3.1: GV10/GV7.5 Available Options
ITEM/
FEATURE FACTORY
CONFIGURATION AVAILABLE
OPTIONS WHEN TO
INSTALL?
HOW TO INSTALL?
Exciter Exciter A (NAE107* ) Exciter B (NAE107*) Station
convenience
See
“Upgrading to Dual
Exciter” on page 2.3.2
UPS Interface None UPS Interface Assembly
and ac input connectors
(219-5179); user provides
UPS and wiring Station
convenience
See
“Installing the UPS
Interface” on
page 2.3.3
Internal Audio
Processor None Orban Inside Kit(s) (for
one or both exciters, as
desired) Station
convenience
See
“Installing the
Orban Inside Card” on
page 2.3.4