Nautel GV10, Installation Manual

Page: 12 / 62

GV10/GV7.5 INSTALLATION MANUAL UNPACKING AND POSITIONING
PAGE 2.2.2 VERSION 3.0 2014-11-01
6. Install the RF output connector, which was partially disassembled for shipment, as follows (see
Figure 2.2.4 on page 2.2.6 ):
NOTE
: The RF output connector was factory configured prior to shipping for the desired EIA connector
(1-5/8 inch, 3-1/8 inch or 7/8 inch).
 Remove the output cover packing plate from the RF output connector on top of the
transmitter. The packing plate - along with two spacer plates - is secured using four M6
screws. Remove only the packing plate, leave the spacer plates in place and retain the screws.
 Obtain the “Output Stud Plate”, which was tyrapped in the rear of the transmitter. Using the
M6 screws retained above, install the output stud plate on top of the spacer plates. Firmly
tighten M6 hardware. Note that the output stud plate’s studs contain the necessary securing
hardware (nuts, flat washers and split washers) to connect the RF output to a dummy load or
the antenna system in
Section 2.9, “Commissioning” .
7. Verify that the RF feed cable reaches the RF output connector on the top of the cabinet. The RF
feed cable will be connected in
Section 2.6, “Installing the RF Feed Cable” .
8. Proceed to Section 2.3, “Installing Options” to configure your transmitter for any options that were
purchased.
9. Do not re-install the rear panels at this time.