https://www.naturewater.eu
Item 50808 and others
Page 7
09 2021
-1
Fig. 14: Quick fit-
ting connect PE
hose
PP-Rohr
Fig. 13: Faucet on coun-
tertop
Fig. 15: Quick fit-
ting disconnect
PE hose
Fig. 16: Quick fitting connect
PE hose
1. To install the ball valve, fit a three-way feed water connector
(A)
and place the ball valve
(B)
on
the three-way feed water connector
(A),
then connect the water-tap with the three-way feed
water connector (Fig. 10 and 11). If a pressure reducing valve is used, connect it (Fig. 12).
2. To install the RO membrane, screw off the cap of the RO housing
(J),
put the one end with two
sealing rings of RO membrane
(I)
first into the RO housing, then screw on the cap tight.
3. The goose-neck water-tap
(Q)
should be positioned for good aesthetics, function and conven-
ience; it connects to the outlet fitting of the activated carbon filter
(P)
by means of a white plastic
hose.
4. Install the plastic hose at following positions according to technological process. There are
marks numbered 1, 2, 3, 4, on the Reverse osmosis system layout and components chart
.
•
Mark 1:
between water tap and PPF filter
(C)
with white plastic hose.
•
Mark 2:
installing a drain tubing white plastic hose linking to the outlet of drain restrictor and
flush valve. Connect the drain tubing to sewer or connect with a container where you can
collect water which can be used for washing or for the toilet.
•
Mark 3:
between the valve outlet
(M)
on water storage tank
(N)
and the Tee in front of ac-
tivated carbon filter
(P)
with white plastic hose.
•
Mark 4:
Between the goose-neck water-tap
(Q)
and the activated carbon filter
(P)
or mineral
ball filter if available.
5. a) Method of connecting plastic hose with fittings
•
Cut a plastic tube according to measurement.
•
Insert the plastic tube into the hexagon nut (Fig. 16).
•
Place the white hose connector in the end piece of the white plastic hose, press the hose
connector into the plastic hose by hand or with a tool (Fig. 16).
•
Place the plastic hose in the connector (Fig. 16).
•
Tighten the hexagon nut.
5. b) Method of connecting plastic hose with quick fittings (Pic. 14)
•
Cut a plastic hose after measuring.
•
Insert plastic hose deep into the quick fitting
5. c) Method of disconnecting the plastic hose from the quick fittings (Pic. 15)
•
Remove the small part.
•
Press the round part until it touches the main body of the quick fitting.
•
Remove the plastic hose.
6. Power cord: This system is equipped with a transformer which uses single-phase power supply
of 220
–240 V (see transformer voltage). To use it, plug the power cord of the transformer into
the power supply socket.
