https://www.naturewater.eu
Item 50808 and others
Page 11
09 2021
-1
1. When the high-pressure switch determines that the water pressure in-
side the tank is lower than the pre-set value, the system starts operat-
ing.
2. The two last digits show the actual TDS value. The TDS value upper
limit is 100 ppm. If the value exceeds 100 ppm, the symbols
“100” and
“TDS” flash one after another.
3. If the TDS value is higher than 50 and if the buzzer mode (
“E”) is acti-
vated, a buzzer sounds.
4.
The first digit shows “E” for the buzzer mode and “P” for the mute
mode, the last of
which can be activated by pressing the “MUTE” but-
ton.
5. Both the probe and the control unit regulate possible deviations in the
measuring range; do
not
combine the system with other devices.
6. The TDS measurement can easily be perturbed. Ensure that the probe
has been introduced to as sufficient depth inside the pipe to guarantee
accurate measuring results.
7. The presence of air bubbles inside the tubing system can influence on
the accuracy of the TDS measurement. Purge the pipes before using
the system. (The high-pressure pump works, the inlet valve opens, the
outlet valve closes.)
1. The system is activated and is rinsed for 30 s.
2. Cumulative water production for 6 h; do not rinse the system during
that time, it will afterwards be rinsed automatically for 30 s.
3. Automatic rinsing for 30 s after the lack of water programme having
been finished.
4. The last two digits show the remaining back-flushing time, the clock
symbols flushes once per second.
5.
The first digit shows “E” for the buzzer mode and “P” for the mute
mode, the last of which ca
n be activated by pressing the “MUTE” but-
ton.
6. Rinse the system for 5 s before the water production and the water
tank filling. (The high-pressure pump works, the inlet valve opens, the
outlet valve closes.)
1. When the high-pressure switch determines that the water pressure in-
side the water tank has reached to pre-set value, the water production
is stopped.
2. Shows the last measured TDS value during the water production or
rinsing. When the system does not produce any water, there is no TDS
