EN-6
EN-7
EN
EN
If the thermometer measures an elevated tempera
-
ture of 37.50 °C or above, the display will illuminate
yellow and/or 10 beeps will sound in rapid succes
-
sion. The display switches between showing the tem-
perature and “HI” (fever alert, Figure 8).
The device now tries to establish a Bluetooth con-
nection to transfer the measured value to the Natural
Cycles app. Make sure that the smartphone is within
range, Bluetooth is enabled and the Natural Cycles app
is running.
If the connection is successful, the “APP” indicator ap
-
pears (Figure 9). Once the data has been transferred,
the thermometer switches off automatically (Figure 10).
If the device cannot establish a connection, the meas
-
urement value is stored on the device to be transferred
later. The device can temporarily store up to 30 meas-
urement values. The thermometer then switches itself
off (Figure 10).
If the measurements cannot be transferred to the Natural Cycles app im
-
mediately after the measurement (e.g. if your smartphone is not within
Bluetooth range or the Natural Cycles app is not open), you can transfer the
measurements to the Natural Cycles app at a later date. To do so, proceed
as follows:
The thermometer has a measurement value memory with 30 save slots.
The measurement values are saved automatically together with the date
and time of the measurement. The most recently measured value is stored
in save slot 1; the value measured prior to that is stored in save slot 2, and
so on. If more than 30 measurements are taken, the oldest value (no. 30) is
deleted so that the most recent value (no. 1) can be saved.
The measurement values and lots of additional infor-
mation are saved in the Natural Cycles app, where they
can be analysed with ease.
You can also recall the last 30 readings directly from
the NC° Thermometer (Gen2). To do so, proceed as
follows:
By repeatedly pressing the Bluetooth button, you can
call up the previous measurements (no. 2, no. 3 ...).
If no measurement values are saved, the following
appears on the display (Figure 4):
With the device switched off, press and hold the Blue-
tooth button for at least 5 seconds until the icon ap
-
pears on the display. The device switches to memory
mode (Figure 1).
The most recently measured value, no. 1, is now dis
-
played (Figure 2, Figure 3). The display switches be-
tween the measurement value and the year, month/
day and time. For measurement values that have been
transferred to the Natural Cycles app, the symbol
is displayed.
Open the Natural Cycles app on your smartphone.
The device now connects to the app via Bluetooth
(Figure 1).
If the connection is successful, the “APP” indicator ap
-
pears (Figure 2).
If the device cannot connect to the Natural Cycles app,
it switches itself off after 60 seconds. If this occurs,
check whether Bluetooth is enabled on your smart-
phone and that the Natural Cycles app is running, then try again.
With the device switched off, press and hold the Bluetooth button for at least
1 second, but no more than 5 seconds, until the Bluetooth symbol
appears
in the display. If you hold down the button for more than
5 seconds, you will enter memory recall mode.
Figure 8
Figure 9
Figure 10
MANUALLY TRANSFERRING DATA TO THE NATURAL CYCLES APP
RECALLING SAVED MEASUREMENT VALUES
Figure 2
Figure 1
Figure 1
Figure 2
Figure 3
Figure 4
A long beep indicates that the measurement is com-
plete. If the sound is deactivated, the display flashes
to indicate that the measurement is complete. The
measurement value is shown on the display (Figure 7).
Figure 7
