National 5200 PANTHER, Instruction Manual

Page: 55 / 100

Page 42
5200 & 5200QL MACHINE MAINTENANCE
SEAT REPLACEMENT
1. Remove two button hexhead screws on each side of the hood (4 times).
2. Lift hood off.
3. Remove seat.
4. To replace seat, set seat on top of hood.
5. Replace the four 5/16 button hexhead screws from underneath the hood.
6. Firmly tighten.
7. Reconnect back-up beeper and seat switch wires.
8. Replace hood and screws.
FUSE REPLACEMENT
The 5200 & 5200-QL has two fused lines. The first is contained in the power box, 15 amp. Open the
power box to replace the fuse. The second fuse is in the positive line on the top of the motor, 100 amp.
To replace, remove the pump guard housing four screws (2 on each side). Pull fuse from the fuse holder,
replace fuse. It only fits one way.
*Note: KEEP ELECTRIC BOX CLEAN. During heavy use, open the electric box and clean thoroughly.
SWITCHES
There are three switches:
1. Operation Switch in handle
2. Kill Switch located on the outside of the power box
3. Motor Starter Switch on connector located inside power box.
WARNING: Always disconnect from power pack before maintaining.
WARNING: Never operate machine without pump guard housing in place.
#5200-258
DEBRIS DEFLECTOR MOUNTING INSTRUCTIONS
•Insert and secure a cutting head, making sure cutting head is all the
way in .
• If there are holes on your lower cutting head support, place debris
deflector under the lower cutting head support and bolt in place.
• If there are not holes on the lower cutting head support, place
debris deflector on the lower cutting head support, measuring a 1''
clearance between the cutting head and the front of the debris deflector.
This clearance will reduce a “pinch point”.
•Secure with C-clamps.
•Mark the holes from the debris deflector on the lower cutting head
support.
•Either drill a 1/2'' hole on each mark and secure debris deflector with a
bolt and lock nut OR drill a 27/64'' hole and tap 1/2-13.
•Firmly secure debris deflector under the cutting head.
Lower Cutting
Head Support
1''
Clearance
Debris
Deflector
Insert & Secure
Cutting Head