National 5200 PANTHER, Instruction Manual

Page: 53 / 100

Page 40
5200 & 5200QL MACHINE MAINTENANCE
HYDRAULIC CYLINDER CHANGE OUT
1. Disconnect machine from power.
2. Disconnect cylinder lines. Have a container ready to catch oil from lines.
3. Remove cylinder securing hexhead bolt from lower cutting head support.
4. Remove clips and pin from cylinder and slide plate.
5. Remove cylinder upper pin.
6. Remove cylinder.
BATTERY PACK
If the Battery Pack is damaged, it must be replaced by the manufacturer or its service agent in order to
avoid a hazard.
WHEEL CHANGING
1. Jack machine up by pushing the cylinder lift forward to lower and adjust the angle of the cutting head
to raise machine.
2. Place blocks under Forklift Cups on the side of the machine that wheel is being changed.
Take Caution: Make sure machine is supported properly or serious injury could occur.
3. Let cylinder down resting machine on blocks allowing rear wheel to be lifted off the floor.
4. Remove five 1/2'' lug nuts with an extended arm wrench, remove wheel.
5. Replace wheel.
6. Replace five lug nuts and tighten, making sure lug nuts are very tight.
7. Raise cylinder to raise machine off of blocks. Remove blocks and lower machine.
8. Repeat to other side if necessary.