National Semiconductor DS25CP104, User Manual

Page: 13 / 36

DS25CP104EVK User Manual
Load the driver
This needs to be done only once for a particular PC.
•
Plug in the USB cable from the PC to the CP104 EVK; a small window should
appear in the lower right corner of the PC recognizing new hardware.
If the
bubble says “USB device not recognized”, or nothing happens, check the
jumper configuration, if still does not work remove jumper on J4 for 5 sec,
and then replace
. The USB controller is now reset and should be in
communication with the PC; this can be known by “Hi speed USB device plugged
into non Hi Speed USB hub” appearing in the window.
•
Follow the instructions for New Hardware Wizard, which may take up to one
minute to run.
a. select “Install from a list or specific location”
b. select “Don’t search I will choose the driver to install”
c. select “Have disk”
d. Browse to “C:\Program Files\National Semiconductor Corp\Analog
LaunchPAD v1.07\Drivers”
e. select “NSC ALP Nano” from the list
f. install the driver
g. hit “Continue Anyway” if windows compatibility window is displayed
h. finish, you are now ready to run the Analog Launch Pad
Page 13 of 17