DS10BR150EVK User Manual
DS10BR150 Evaluation
This section provides recommended test setup procedure for the device evaluation. Figure 2 depicts a
typical setup and instrumentation you may use for the device evaluation.
1.
Apply the power to the device (3.3V typical) between VDD2 and GND connectors.
2.
Connect a signal source (i.e. signal generator or an LVDS driver) to the input (R1 label) on the
board and adjust the signal parameters (VOH, VOL, VCM) so that they comply with the device
input recommendations.
3.
Connect the output (U1 label) to an oscilloscope and view the output signals with an oscilloscope
that has the bandwidth of at least 3 GHz.
Figure 2.
DS10BR150 Test Setup Example
Page 4 of 5
Summary of Contents for DS10BR150EVK
Page 6: ......