Remote monitor operation
10
The input source (ALT or SOLAR) as well as charge current is displayed
during a charge cycle.
If SOLAR is the active charge source, the solar panel voltage is displayed.
If there are no active charge cycles, “STBY” is displayed.
Display mode 1
- This mode focuses on the auxiliary battery with the
majority of the screen used to show the auxiliary battery voltage and
battery temperature.
The remote monitor can be turned ON or OFF by pressing the
POWER
button.
The display will turn off automatically after a short delay if there is no active charge cycle.
The display brightness can be increased or decreased by pressing the
UP
or
DOWN
buttons.
The actual voltages are shown for the respective batteries.
During a charge cycle, the input source (ALT or SOLAR) is displayed with
the actual charge current.
If there is no active charge cycle, “STANDBY” is displayed.
The AUX graph is animated during charge and represents the battery state
of charge.
Display mode 2
- In this mode, the status of the main and auxiliary
batteries are represented as graphical bar-graphs.
If there are no active charge cycles, “STBY” is displayed.
Display mode 3
- This mode shows voltages of the respective main and
auxiliary batteries as well as charger mode, charge current, battery type
and battery temperature.
The remote monitor has 3 display modes that represent the status of the charging system in different
ways.
Press the
MODE
button to cycle through the different display options.
