Table 15. USRP-2945 Module Front Panel Connectors (Continued)
Connector
Use
AUX I/O
General-purpose I/O (GPIO) port. AUX I/O is controlled by the FPGA.
RF 1 RX1 Input terminal for the RF signal. RX1 is an SMA (f) connector with an
impedance of 50 Ω and is a single-ended input or output channel.
RX2 Input terminal for the RF signal. RX2 is an SMA (f) connector with an
impedance of 50 Ω and is a single-ended input channel.
Note
The LED indications described in the following table occur only when you
use the NI-USRP API with the default API image. When you use LabVIEW FPGA,
you customize the LED indications.
Table 16. USRP-2945 Module LEDs
LED
Description
Color
State
Indication
RF 0 RX1 Indicates the receive
status of the module.
OFF
—
The module is not receiving.
Green
Solid
The module is receiving data.
RX2 Indicates the receive
status of the module.
OFF
—
The module is not receiving.
Green
Solid
The module is receiving.
REF
Indicates the status of the
reference signal.
OFF
—
There is no reference signal,
or the device is not locked to
the reference signal.
Green
Blinking The device is not locked to
the reference signal.
Solid
The device is locked to the
reference signal.
PPS
Indicates the pulse per
second (PPS).
OFF
—
There is no PPS timing
reference signal, or the
device is not locked to the
reference signal.
Green
Blinking The device is locked to the
PPS timing reference signal.
28
|
ni.com
|
USRP-2940/2942/2943/2944/2945 Getting Started Guide