Table 14. USRP-2944 Module Back Panel Connectors (Continued)
Connector
Use
PPS TRIG OUT Output terminal for the pulse per second (PPS) timing reference. PPS
TRIG OUT is a female SMA connector with an impedance of 50 Ω, and it
is a single-ended input. The output signal is 0 V to 3.3 V TTL. You can
also use this port as triggered output (TRIG OUT) that you program with
the PPS Trig Out I/O signal.
PPS TRIG IN
Input terminal for pulse per second (PPS) timing reference. PPS TRIG IN
is a female SMA connector with an impedance of 50 Ω, and it is a single-
ended input channel. PPS TRIG IN accepts 0 V to 3.3 V TTL and 0 V to
5 V TTL signals. You can also use this port as a triggered input (TRIG IN)
that you control using NI-USRP software.
GPS ANT
Input terminal for the GPS antenna signal. GPS ANT is a female SMA
connector with a maximum input power of -15 dBm and an output of
DC 5 V to power an active antenna.
Caution
Do not terminate the GPS ANT port if you do not use
it.
USRP-2945
Figure 13. USRP-2945 Front Panel
Table 15. USRP-2945 Module Front Panel Connectors
Connector
Use
JTAG
A USB port that connects the host computer to the device FPGA for recovery
purposes. This port can be used with the Xilinx iMPACT configuration tool to
temporarily load a new bitfile.
RF 0 RX1 Input terminal for the RF signal. RX1 is an SMA (f) connector with an
impedance of 50 Ω and is a single-ended input or output channel.
RX2 Input terminal for the RF signal. RX2 is an SMA (f) connector with an
impedance of 50 Ω and is a single-ended input channel.
USRP-2940/2942/2943/2944/2945 Getting Started Guide
|
© National Instruments
|
27
