National Instruments SCXI SCXI-1102, User Manual

Page: 79 / 85

© National Instruments Corporation I-1 SCXI-1102/B/C User Manual
Index
Symbols
+5 V signal
front connector signal (table), 2-3
front signal pin assignment (table), 2-2
A
adjusting timing and triggering, 5-3
AI GND signal (table), 2-7
AI HOLD COMP signal (table), 2-7
AI HOLD signal (table), 2-7
AI31– through AI0– signals (table), 2-3
AI31+ through AI0+ signals (table), 2-3
amplifier characteristics specifications, A-2
analog circuitry
analog input channels, 4-2
CJ SENSOR, 4-2
analog input channels, 4-2
analog input signal connections, 2-3
ground-referencing of signals, 2-4
floating signal connection referenced
to chassis ground (figure), 2-6
ground-referenced signal connection
(figure), 2-5
analog input signals, multiplexed, 4-3
analog input specifications
amplifier characteristics, A-2
dynamic characteristics, A-2
input characteristics, A-1
transfer characteristics, A-1
application software, installation, 1-4
applications
developing in NI-DAQmx, 5-1
acquiring, analyzing, and
presenting, 5-7
completing, 5-7
LabVIEW, 5-7
program flowchart (figure), 5-2
programmable properties, 5-13
specifying channel strings, 5-10
Traditional NI-DAQ (Legacy), 5-13
B
bent and trimmed resistor (figure), E-2
C
C language and low-level DAQ functions, 5-16
cables, custom, 2-1
calibration, SCXI-1102/B/C, 5-18
CH 0– signal (table), 2-7
CH 0 signal, multiplexing, 2-8
CH 0+ signal (table), 2-7
CH GND signal, 2-6
front connector signals (table), 2-3
front signal pin assignment (table), 2-2
channel properties, configuring, 5-4
channel scanning.
See multiplexed scanning
channel strings, verifying signals, 3-6
channels, voltage measurement flowchart
(figure), 5-2