Chapter 1
About the SCXI-1102/B/C
©
National Instruments Corporation
1-5
Connecting the SCXI-1102/B/C in an SCXI Chassis to an E/M Series
DAQ Device for Multiplexed Scanning
Refer to the
SCXI Quick Start Guide
to install the cable adapter and connect
the SCXI modules to the E/M Series DAQ device.
If you have already installed the appropriate software, refer to Chapter 3,
, to configure the SCXI-1102/B/C module(s).
Connecting the SCXI-1102/B/C in a PXI/SCXI Combination Chassis to an
E/M Series DAQ Device for Multiplexed Scanning
Refer to the
SCXI Quick Start Guide
to connect the SCXI modules to the
E/M Series DAQ device.
If you have already installed the appropriate software, refer to Chapter 3,
, to configure the SCXI-1102/B/C module(s).
Verifying the SCXI-1102/B/C Installation in Software
Refer to the
SCXI Quick Start Guide
for information on verifying the SCXI
installation.
Installing SCXI Using NI-DAQmx in Software
Refer to the
SCXI Quick Start Guide
for information on installing modules
using NI-DAQmx in software.
Manually Adding Modules in NI-DAQmx
If you did not auto-detect the SCXI modules, you must manually add each
of the modules. Refer to the
SCXI Quick Start Guide
to manually add
modules.
Note
NI recommends auto-detecting modules for the first time configuration of the
chassis.
Installing SCXI Using Traditional NI-DAQ (Legacy) in Software
Refer to the
SCXI Quick Start Guide
for information on installing modules
using Traditional NI-DAQ (Legacy) in software.
