Chapter 2
Installation and Configuration
2-12
www.ni.com
Consult the documentation for your SCXI/PXI chassis and accessories for
additional instructions and warnings. To remove the SCXI-1104/C module
from an SCXI chassis follow the steps that follow while referring to
Figure 2-3:
1.
If the SCXI-1104/C is the cabled module, disconnect the cable running
from the SCXI-1104/C to the DAQ device.
Caution
Read the safety information in the appropriate section that follows and in the
associated terminal block installation guide before adding or removing any signals from
the SCXI module or terminal block.
2.
Remove all signals from the terminal block connected to the
SCXI-1104/C.
3.
Remove any terminal blocks connected to the SCXI-1104/C.
4.
Turn off the SCXI chassis. Do not remove the SCXI-1104/C module
from a chassis that is turned on.
5.
Rotate the thumbscrews that secure the SCXI-1104/C to the chassis
counter-clockwise until they are loose, but do not completely remove
the thumbscrews.
6.
Remove the SCXI-1104/C by pulling steadily on both thumbscrews
until the module slides completely out.
