Chapter 2
Installation and Configuration
©
National Instruments Corporation
2-13
Figure 2-3.
Removing the SCXI-1104/C
Removing the SCXI-1104/C from Measurement & Automation Explorer
To remove a module from Measurement & Automation Explorer, take the
following steps after entering the Measurement & Automation Explorer
utility:
1.
Display the list of installed devices and interfaces by clicking the +
next to the Devices and Interfaces icon.
2.
Locate the chassis in the list of installed devices. Display the list of
modules in the chassis by clicking the + next to the Chassis icon.
3.
Right-click the module or chassis you want to delete and select Delete.
4.
You will be presented a confirmation window. Click Yes to continue
deleting the module or chassis or No to cancel this action.
1
Cable
2
SCXI Module Thumbscrews
3
SCXI-1104/C
4
Terminal Block
5
SCXI Chassis Power Switch
6
SCXI Chassis
®
MAINFRAME
SCXI
3
4
2
1
5
6
SCXI
1100
+
–
!
