National Instruments PXIe-5763, Getting Started Manual

Page: 9 / 15

Connector Description Function
DIO Molex
™
Nano-Pitch DIO
connector
Multi-signal DIO connector that provides
access to FPGA multi-gigabit transceivers
(MGTs)
1
and general-purpose input/output
(GPIO) signals.
AI <3..0> Standard SMA female
connector
Analog input connection.
REF/CLK IN Standard SMA female
connector
Input for an external Reference Clock or
Sample Clock.
The following table lists the available pins on the DIO connector.
Signal Type Direction
MGT Tx± <3..0>
1
Xilinx UltraScale GTH Output
MGT Rx± <3..0>
1
Xilinx UltraScale GTH Input
DIO <7..0> Single-ended Bidirectional
5.0 V DC Output
GND Ground —
Notice
The maximum input signal levels are valid only when the module is
powered on. To avoid permanent damage to the PXIe-5763, do not apply a signal to
the device when the module is powered down.
Notice
Connections that exceed any of the maximum ratings of any connector on
the PXIe-5763 can damage the device and the chassis. NI is not liable for any
damage resulting from such connections.
Configuring the PXIe-5763 in MAX
Use Measurement & Automation Explorer (MAX) to configure your NI hardware. MAX
informs other programs about which NI hardware products are in the system and how they are
configured. MAX is automatically installed with FlexRIO Support.
1. Launch MAX.
2. In the configuration tree, expand
Devices and Interfaces to see the list of installed NI
hardware.
Installed modules appear under the name of their associated chassis.
1
MGTs are available only on devices with KU040 and KU060 FPGAs.
8 | ni.com | PXIe-5763 Getting Started Guide