National Instruments PXIe-5763, Getting Started Manual

Page: 13 / 15

PXIe-5763 CLIP
The PXIe-5763 CLIP provides access to four AC- or DC-coupled analog input channels.
In the LabVIEW FPGA Module, 16-bit analog input data is accessed using an I16 data type.
The DIO signals are grouped into two ports of four signals each and are accessed using a U8
data type and a Boolean write enable signal. The four PFI signals are accessed individually
using Boolean signals.
Making a Measurement
Making a Measurement with LabVIEW
1. Launch LabVIEW.
2. Select
Help » Find Example .
3. Open the example VI that you want to use by selecting Hardware Input and Output »
FlexRIO .
4. Follow any setup, configuration, and execution instructions in the VI.
Troubleshooting
If an issue persists after you complete a troubleshooting procedure, contact NI technical
support or visit
ni.com/support
.
What Should I Do if the PXIe-5763 Doesn't Appear in
MAX?
1. In the MAX configuration tree, expand Devices and Interfaces .
2. Expand the Chassis tree to see the list of installed hardware, and press <F5> to refresh
the list.
3. If the module is still not listed, power off the system, ensure that all hardware is correctly
installed, and restart the system.
4. Navigate to the Device Manager.
Operating System Description
Windows 10/8.1 Right-click the Start button, and select Device Manager .
Windows 7
Select
Start
»
Control Panel
»
Device Manager
.
5. Verify the PXIe-5763 appears in the Device Manager.
a) Under an NI entry, confirm that a PXIe-5763 entry appears.
Note
If you are using a PC with a device for PXI remote control system,
under System Devices , also confirm that no error conditions appear for the
PCI-to-PCI Bridge .
12 | ni.com | PXIe-5763 Getting Started Guide