Chapter 2 Installation and Configuration
SCXI Module Installation
Follow these steps to install SCXI modules:
1. T u r n off the SCXI subsystem using the switch shown in Figure 1-2,
Rear View of the PXI-1011 Chassis.
2. Remove the front filler panel of an empty SCXI slot, if any.
3. I n s e r t the module into the module guide rails and slide the module to
the back of the chassis. Do
not
force the module into place.
4. S c r e w the front mounting panel of the module to the top and bottom
threaded strips of the SCXI chassis using the thumbscrews on the
module front panel.
5. I n s t a l l any necessary cables, cable accessories, or terminal blocks.
Refer to your SCXI module documentation for specific instructions
pertaining to the module, especially configuration and signal connections.
SCXI Filler Panel Installation
The SCXI front filler panel accessories protect the inside of the SCXI
subsystem by preventing unwanted material from entering the PXI chassis
and damaging modules or forming conductive paths that may degrade
performance. Install all SCXI modules first, then, in any unused SCXI
slots, install filler panels.
Front Filler Panel Installation
Front filler panels are the height of a full slot. Follow these steps to install
SCXI front filler panels:
1. P l a c e the filler panel with the captive screws in front of unused SCXI
slots. Line up the screws with the threaded strip holes.
2. U s i n g a flathead screwdriver, screw the two captive screws into the
threaded strip holes.
PXI-1011 Chassis User Manual
2-4
w
w
w
.
n
i
.
c
o
m
