Chapter 1
Installing and Configuring the SCXI-1129
1-20
ni.com
To set up the SCXI-1129 module to be accessed by a DAQ device through
another SCXI module, refer to Figure 1-7 while completing the following
steps:
Figure 1-7.
Installing the SCXI-1129 with an SCXI Module and a DAQ Device
1.
Connect the MIO/DIO cable adapter to the rear of a module that is not
the SCXI-1129 module. Secure the adapter to the SCXI chassis using
the screws provided.
2.
Attach your DAQ cable to the cable adapter at the rear connector.
3.
Attach the other end of the DAQ cable to the National Instruments
DAQ device.
4.
Check the installation.
5.
Power on the SCXI chassis.
6.
Power on the computer or reconnect it to your chassis.
If you already have the appropriate software installed, you are ready
to configure the SCXI-1129 through an SCXI module other than the
SCXI-1129 module. If you have not installed your software, refer to
the
section of this chapter.
1
Non-SCXI-1129 Module
2
DAQ Cable
3
MIO or DIO Device
4
2-Slot HVAB-Backplane
Adapter
5
SCXI Chassis
6
Digital Signals Connector
7
SCXI-1129 Module
8
HVAB Connector
1
8
5
6
7
3
4
2
Summary of Contents for NI SCXI-1336
Page 1: ...SCXI 1336...
