Caution
Tilting the module when removing it from the DIN rail will damage
the contacts.
Removing Bus Connectors
Complete the following steps to remove bus connectors from the DIN rail.
What to Use
•
Flathead Screwdriver
What to Do
Note
You must remove the preceding module before removing the bus connector.
1
3
2
1.
Slide the bus connector away from the preceding bus connector at least 5.0 mm (0.20 in.).
2.
Insert the screwdriver and loosen both latches on one side of the DIN rail.
3.
Rotate the bus connector to remove it from the DIN rail.
Note
If you want to remove a bus connector in the middle of the system, you
must remove any modules or bus connectors following the desired connector or
slide them along the DIN rail at least 15.0 mm (0.60 in.).
12
|
ni.com
|
REM-11115 Getting Started Guide
