NI DCM-2316 Getting Started Guide
|
© National Instruments
|
11
c.
Select
Custom software installation
.
d.
Click
Yes
.
e.
Select any additional software to install (VeriStand Engine, SCM, etc.)
f.
Click
Next
.
g.
Verify that the summary of software to install is correct.
h.
Click
Next.
4.
Click
Finish
when the installation is complete.
Launching DCM DSI
Complete the following steps to launch and begin using DCM DSI.
1.
Open NI Software Calibration Management (SCM) Console on the host PC.
2.
Select
File
»
Select Target
.
3.
Choose your DCM on the
Select Target
drop-down.
4.
.
5.
Click
OK
.
6.
Click
Start Host Application
on the SCM Console.
Note
The DCM is shipped supporting the latest version of SCM. If you have
trouble launching the DCM DSI with the latest available version of SCM on
,
the software on your DCM may need to be updated. Refer to the
NI DCM-23XX DSI
User’s Guide
for more information.
Troubleshooting the DCM
Safe Mode and IP Reset
The following figure shows the reset behavior of the DCM.
Figure 3.
Reset Behavior
R
u
n Mode
• Network
S
etting
s
Re
s
et
• Con
s
ole O
u
t En
a
bled
• RT
S
t
a
rt
u
p App Di
sa
bled
• FPGA
S
t
a
rt
u
p App Di
sa
bled
Sa
fe Mode with
IP Re
s
et
• Con
s
ole O
u
t En
a
bled
• RT
S
t
a
rt
u
p App Di
sa
bled
• FPGA
S
t
a
rt
u
p App Di
sa
bled
Sa
fe Mode
Cycle Power
Cycle Power
+AI11 (pin 6
3
) to B
a
tt+
+AI12 (pin 55) to B
a
tt+
Cycle Power
+AI12 (pin 55) to B
a
tt+
Cycle Power