10
|
ni.com
|
NI DCM-2316 Getting Started Guide
Installing Software on the DCM (LabVIEW or VeriStand
Personalities)
Complete the following steps to install software on the DCM for LabVIEW or VeriStand
personalities. If using DCM DSI, skip this section.
Note
The DCM ships with the DSI pre-installed. In order to run non-DSI
personalities, the DCM must be formatted. To reinstall the DCM DSI after
formatting, refer to the
NI DCM-23XX DSI User’s Manual
for more information.
1.
In MAX, right-click on your DCM target under Remote Systems.
Caution
Any files, including calibrations, present on the DCM during formatting
will be lost. Prior to formatting, any files present on the DCM must be backed up in
order to be saved. Files may be copied from the DCM by WebDAV file transfer.
a.
Select
Format Disk
.
Tip
You must log in if you set a system password.
b.
Select
Attempt to restart into safe mode
.
c.
Select the desired option to manage network adapter settings.
d.
Click
Format
.
e.
Wait for the formatting process to finish, then click
OK
.
2.
In MAX, expand your system under Remote Systems.
a.
Right-click
Software
.
b.
Select
Add/Remove Software
to launch the LabVIEW Real-Time Software Wizard.
Tip
You must log in if you set a system password.
c.
Select the recommended software set for your LabVIEW and NI-RIO Device Drivers
versions.
d.
Click
Next
.
e.
Verify that the summary of software to install is correct.
f.
Click
Next
.
g.
Click
Finish
when the installation is complete.
3.
To install NI VeriStand or NI SCM on the target, continue with the following steps.
a.
In MAX, right-click
Software
as before
.
b.
Select
Add/Remove Software
to launch the LabVIEW Real-Time Software Wizard.
Tip
You must log in if you set a system password.