Chapter 1
Getting Started
©
National Instruments
1-5
X Series User Manual
Mounting X Series USB Devices
(NI USB-634
x
/635
x
/636
x
Devices)
Yo
u
can
u
se yo
u
r X Series USB device on
a desktop, mo
u
nt it to a wall or panel as described in the
Panel/Wall
Mounting
section, or mo
u
nt it to a standard DIN rail as described in the
DIN
Rail Mounting
section.
Panel/Wall Mounting
Complete the following steps to mo
u
nt yo
u
r USB X Series device to a wall
or panel
u
sing the USB X Series mo
u
nting kit (part n
u
mber 781514-01 not
incl
u
ded in yo
u
r X Series USB device kit). Refer to Fig
u
re 1-3.
1.
Use three #8-32 flathead screws to attach the backpanel wall mo
u
nt to
the panel/wall. Tighten the screws with a #2 Phillips screwdriver to a
torq
u
e of 1.1 N · m (10 lb · in.).
Figure 1-3.
Using the USB X Series Mounting Kit on a Wall or Panel
2.
Place the USB X Series device on the backpanel wall mo
u
nt with the
signal wires facing down and the device bottom sitting on the
backpanel wall mo
u
nt lip.
3.
While holding the USB X Series device in place, attach the
front bracket to the backpanel wall mo
u
nt by tightening the
two th
u
mbscrews.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
