Index
BNC-2090 User Manual
I -2
National Instruments Corporation
F
filters.
See also
highpass filters, lowpass
filters.
analog input, 3-6
building attenuators (voltage
dividers), 3-8
building highpass, 3-6
DIFF channel 1 (figure), 3-8
normalized frequency response
(figure), 3-7
building lowpass filters, 3-5
DIFF channel 1 (figure), 3-6
normalized frequency response
(figure), 3-5
analog output, 3-10
building lowpass filters, 3-11
DAC0OUT (figure), 3-12
building highpass filters, 3-12
DAC0OUT (figure), 3-12
fuse and power LED, A-1
G
general-purpose termination
breadboards, 2-7
connected to MIO (figure), 2-8
connected to BNC-2090 (figure), 2-9
ground jumper, 2-3
setting options (table), 2-4
ground-referenced signal sources, 2-12
DIFF inputs, 2-12
SE inputs, 2-12
H
highpass filters
analog input, 3-6
building filters, 3-6
DIFF channel 1 (figure), 3-8
normalized frequency response
(figure), 3-7
analog output, 3-10
building filters, 3-12
DAC0OUT (figure), 3-12
I
installation, 2-6
accessory-to-board cabling, 2-7
cabling options (table), 2-7
MIO board connection (figure), 2-8
SC-20
XX
board connection (figure), 2-9
J
jumper, W1 shield ground, 2-3
setting options (table), 2-4
L
lowpass filters
analog input, 3-6
building filters, 3-5
DIFF channel 1 (figure), 3-6
normalized frequency response
(figure), 3-5
analog output,3-10
building filters, 3-11
DAC0OUT (figure), 3-12
M
MIO board, 2-1
analog input, 3-3
analog output, 3-10
mode configuration, 2-2
DIFF input mode, 2-2
RSE and NRSE input mode, 2-2
N
nonreferenced (or floating) signal
sources, 2-11
DIFF inputs, 2-11
bias return resistor for DC-coupled
floating source on channel 1
(figure), 2-11
SE inputs, 2-12
