National Electronics & Watch Co,. Ltd.
BC10
Step 2) Charging the Battery:
Charge the unit for at least 4.0 hours before first use. The length of time for a fully charged
battery will last depending on the actual usage. It is recommended to regularly re-charge your
battery every 1-2 months even if it is not used to maintain good battery condition.
2.1)
Plug your USB cable to your PC
2.2)
Align the charging clip with the 4 contact pins on the back of the watch.
2.3)
Connect the charging clip securely to the watch.
Note: Please thoroughly dry the charging contacts and surrounding area to ensure proper
electrical contact and prevent corrosion.
When the battery is low, it is time to charge the GPS watch. The possible screen when you
charge your watch. Once the battery is full, it will display CHARGE 100% FULL.
Battery low condition:
You cannot turn ON the GPS when the battery is low. The watch will display BATT LOW. The
battery icon will also blink. You need to recharge the battery in order to use the GPS again.
When the battery is almost low and you still perform your exercise, your data may not be saved
if the battery becomes low. Please make sure the battery have enough battery power before
doing your exercise in order not to lose your data.
When the battery level becomes very low, the watch will automatically turn OFF the display
(blank-screen).
Step 3) Configure your watch:
Before using your GPS watch, User can opt to do the following.
3.1)
Go to
SET
mode to set the following parameters:
AUTO LAP, TIME, UNIT
,
USER’
details,
HRM,
HRM LINK
,
NIGHT, CONTRAST, CHIME, ALARM and TIMER.
Step 4) Acquire Satellite signals:
To get the correct time of day and begin using your GPS watch, you have to acquire GPS
signals. It may take few minutes to acquire the satellite signals.
4.1)
Go outside to an open area away from tall buildings and trees. Orient the GPS antenna
towards the sky for best reception. The antenna is located at the 6 o’clock position of the
watch.
Note: In order to accurately navigate the GPS, you need to have a good line of sight to the
satellites.
4.2)
Stand still and do not begin moving while searching the Satellite signals until the signals
are already received.
4.3) How to turn ON the GPS:
While in Time mode,
press S1 or S7 to go to RUN mode. The
watch will start locating the satellites “SEARCH GPS”. After receiving the GPS signals, it
will automatically go to RUN mode and the watch will display “GPS GO” while the
“CHRONO” blinks.
Also note that the watch will display the relative signal strength indicator on the upper side
(12H position).
4.4) How to turn OFF the GPS
:
If you wish to turn OFF the GPS, press and hold S7 in Time
mode for about 3 seconds and the watch will momentarily display GPS OFF and then
return to Time view.
