WIRE HARNESS INSTALLATION-
ROCKER SWITCH TO DASH, SECTION C
1. Locate the section of Wire Harness (c) that
terminates in the Two-Way Rocker Switch. Tem-
porarily remove the Rocker Switch.
Figure 10
Tape the wire ends to prevent snagging.
2. Route section c of the Wire Harness to the
hole cut in the dash. Thread the Wire End (c)
through the hole.
Figure 10
3. Reattach the Two-Way Rocker Switch to the
two Nylon Pin Connectors (polarity doesn’t mat-
ter) and then push the Rocker Switch into the
cutout.
Figure 11
WIRE HARNESS INSTALLATION- BATTERY
TERMINUS A
Do Not fully secure Wire Harness with
Zip Ties until after the windshield is
installed.
1. Remove seat from vehicle to access battery
compartment.
2. Locate Battery terminus section (a) of the Wire
Harness.
3. Following the vehicle’s main wire harness
route the Battery terminus end (a) down toward
vehicle’s lower main frame rails.
Figure 13
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-0400 F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2016 National Cycle, Inc.
Page 7 of 13
10-118015-000 11/16
Figure 12
c.
c.
Figure 10
Figure11
Figure 13
a.
