4. Use the parts shown in Illustration B to fasten the
Windshield to the Clamp (10) at the side Frame. Orient
the clamps so that the male half (with embossed part
number) is toward the front of the vehicle. Tuck Wire
Harness between Clamp and Windshield. Install Clamps,
but do not fully tighten.
(Phillips Screwdriver or
Power Drill on low setting) Illustration B and Figure
23
5. Check the alignment and position of the windshield
and make sure it is even and symmetrical.
FINALIZE CONNECTIONS TO WIPER
1. Use a Tie Wrap (23) to gather the ends of Terminus d
Section.
(Wire Cutters) Figure 24
2. Connect the Wiper Motor Power and Fluid Hose.
Figure 25
A little moisture on the Fluid Hose end will
make them join easier.
3. Tuck Motor Connector behind Motor assembly.
FINAL TIGHTENING and REINSTALLATION OF
PARTS REMOVED FROM VEHICLE
1. Adjust Wire Harness to remove all slack at:
1. d. Terminus Section to Wiper Motor
2. b. Terminus Section Fluid Reservoir
3. c. Terminus Section to Dash
4. a. Terminus Section to Dash
2. Securely tighten the Machine Screws (13) in all Wrap-
around Clamps (10).
3. Use the Zip-Ties (22 and 23) to coil and secure the
Wire Harness thoroughly within the vehicle:
Under Hood, Figure 26
In Wheel Well, Figure 27
Along Frame, Figure 28 and 29
In Battery Compartment, Figure 30
4. Reinstall the seat.
Figure 23
Figure 24
Figure 25
Figure 26
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-0400 F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2016 National Cycle, Inc.
Page 11 of 13
10-118015-000 11/16
d.
