WINDSHIELD INSTALLATION
Install Clamps
Read these helpful tips for a smooth instal-
lation of Clamps:
Follow the sequence.
Note the hex shape of Retainer Pin (11),
and male Clamp (10) half.
While installing the windshield Clamps
(10), tuck Wire Harness between
Clamp and Windshield.
Start Machine Screws (13) but do not
tighten.
Installation of Top Clamp LEFT Side
1. Use the parts shown in Illustration A to fasten
the Windshield Bracket (25) to the Clamp (10).
Do not fully tighten.
(Phillips Screwdriver or
Power Drill on low setting) Figure 21 and
Illustration A
Installation of Top Clamp CENTER
2. Use the parts shown in Illustration A to sup-
port Wire Harness to Top Frame Tube. Do not
fully tighten.
(Phillips Screwdriver or Power
Drill on low setting) Figure 22 and
Illustration A
Installation of Top Clamp RIGHT Side
3. Use the parts shown in Illustration B to fasten
the Windshield Bracket (25) to the Clamp (10).
Do not fully tighten.
(Phillips Screwdriver or
Power Drill on low setting) Illustration B
Figure 21
Figure 22
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-0400 F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2016 National Cycle, Inc.
Page 10 of 13
10-118015-000 11/16
FRONT OF VEHICLE
11
12
10
13
26
Illustration A,
Top Clamp LEFT and CENTER
Illustration B
Center Clamp, Supports Wire Harness
(26) Preinstalled
on Bracket or
(16) Installed at
center clamp.
11
10
13
15
