WINDSHIELD WIPER OPERATION
The Wiper is intended for use with the wash
cycle or during rain. DO NOT Wipe a dry wind-
shield.
DO NOT run the Pump without fluid.
The Wiper Motor has an on/off Rocker Switch as shown.
Turn the switch on and verify that the Wiper works as
expected.
The dash panel Rocker Switch installed controls the fluid
spray. Momentarily hold the Switch in the on position to
spray water from the Wiper Arm. It should spray in four
separate directions.
The 4 spray jets can be redirected carefully.
WIPER ARM AND BLADE
Your Wash’n”Wipe Windshield is equipped with a quality
silicone Wiper Blade. Replacement Wiper Blades are
available from your local dealer or by contacting National
Cycle.
Replacement Wiper Blade Part Number is N30900
Replacement Wiper Arm Part Number is N30911
REPLACING THE WIPER BLADE AND ARM
Open the small access cover on the Wiper Blade and
pull the blade twowards the motor end of Wiper Arm to
loosen blade.
Join the end of the Wiper Arm (6) to the Wiper Blade (7).
Place the J-hook of the Arm over the Blade’s plastic
mounting clip until it clicks and locks into place. Close the
small access cover.
Figure 22
Swivel up the mount cover of the Wiper Arm as shown
and then mount the Wiper Arm over the Motor’s Spindle.
Figure 23
Once the Wiper Arm is on the Spindle, install the Internal
Tooth Lock Washer and Small Mounting Nut. Use a
torque wrench to tighten the Small Mounting Nut to 16
foot-pounds (22Nm). Then swivel the mount cover of the
Wiper Arm back to its closed position.
Figure 24 (Torque Wrench)
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-0400 F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2016 National Cycle, Inc.
Page 13 of 13
10-118015-000 11/16
6
7
Figure 31
Figure 32
Figure 33
