16
Then place the 2.25 Ounce weight that came with the machine at 12 0’clock on the
outside of the rim using the provided wheel hammer. After placing the weight, close the
hood and spin the wheel. The following screen will appear:
You have now zeroed out the balance for the outside of the rim.
Use your hand to rotate the tire until all 5 of the lights in the
INSIDE UNBALANCE
POINT
are on, as shown here:
Now place the 3.00 Ounce weight that came with the machine at 12 0’clock on the
outside of the rim using the provided wheel hammer. After placing the weight, close the
hood and spin the wheel. The following screen will appear:
You zeroed out both sides and successfully balanced the wheel.
Please note that the machine is showing the wheel is balanced within the parameters you
set in the system settings, specifically the “least unbalance value setting”. In the above
balancing example, my “least unbalance value setting” was set to .70 ounces. After
spinning the wheel and placing the weight, any unbalance value remaining that was less
than .70 ounces was ignored and instead the machine showed it zeroed out.
This is where the
FINE
button comes into function. At anytime while balancing, you can
press the
FINE
button to show the exact unbalance value. The most accurate values are
1 gram or .10 Ounce using the
FINE
button. Please see the following screen. This is the
remaining unbalance value after the balancing example shown above was performed.