16
ACTIve oxygeN
▪
general
The air purification process uses active oxygen; it is based on the generation of ozone (O
3
) in controlled
quantities. Ozone is a very powerful natural detergent and, like bleach or chlorine, this feature must be
used with caution.
Two quite different active oxygen treatment modes have been developed to fulfil all requirements. They are
adapted to the volume of the room and can be adjusted by the user.
- MOdE 1: acts mainly on odour elimination (cigarettes, body odour, drains, etc.). Ozone is generated in
small quantities and enables continuous treatment.
- MODE 2 (Clean Booster): purifies the air in the room intensively by destroying micro-organisms and
persistent odours. Ozone is generated in large quantities, which means the room must be free from people
and animals for 30 minutes.
▪
operation
- MOdE 1 - continuous treatment
• Open the cover. To do so, unscrew the two screws
1
using the torx wrench provided.
• Adjust treatment according to the surface area of the room using the adjustment button
6
.
Turn the button using a small, flat or cross-head screwdriver.
• The adjustment positions are as follows:
•
oFF
- MODE 1 off - no ozone emission
•
1
- low - surface area 5-15m² / slight odour
•
2
- moderate - surface area 10-25m² / notable odour
•
3
- high - surface area 20-45m² / strong odour
By default, the button is in position Off. As the button is turned, a light and sound signal indicates the
selected position:
•
oFF
- no signal
•
1
- One beep and red LEd on the front flashes once
4
•
2
- Two beeps and red LEd on the front flashes twice
•
3
- Three beeps and red LEd on the front flashes three times
The light signal is also activated whenever the unit is switched on, to inform the user of the position setting.
Active oxygen adjustment button
6
:
- MODE 2 - intensive Clean Booster treatment
• Press button
b
on the remote control for 3 seconds.
• The Clean Booster treatment cycle begins. There is a 30-second delay to allow the user to leave the room
and close the door. Then, the ozone generation and recovery cycle is triggered, lasting 30 minutes in total.
An intermittent sound and light signal is active throughout the cycle.
• After 30 minutes, the unit returns to normal operation in the preset mode. you can return to the room.
NB: The effectiveness of the Clean Booster treatment depends on the Mode 1 setting. If the adjustment
button
6
is in the Off position, the default Clean Booster treatment will be intermediary.
IF Mode 2 Is ACTIve
, PLEASE COMPLy WITH THESE SAfETy INSTRUCTIONS.
• do not breathe the ozone directly above the unit.
•
Make sure
No oNe is present
in the room during the
30-minute treatment cycle
(men, women, children,
and also pets). Plants and fish may remain.
• Close doors, windows, and turn off the ventilation system if possible.
