14
desCrIPTIoN
INsTAllATIoN
• Take the unit out of its packaging. keep the original box throughout the unit’s lifespan.
• Open the cover to access the filter compartment. To do so, unscrew the two screws
1
using the torx
wrench provided.
• Remove the two filter latches
9
.
• Remove the filter from its protective packaging and put it into place, with the blue pre-filter visible (there
are arrows on the side of the filter to indicate the air direction).
• If necessary, adjust active oxygen processing (see instructions on page 16).
• Put back in place the filter latches then close the cover using the two screws.
• Place the unit in a stable position on a flat surface.
• Plug the unit into an electrical outlet.
1
Screws x2
2
On/off switch
3
Blue LEd - operation/standby
4
Red LEd - alarm messages
5
Speed adjustment
6
Active oxygen adjustment
7
Reinitialisation of filter use
8
Remote control
9
filter latches x2
before cleaning.
• Clean with a soft cloth.
• do not use the unit in places where
flammable products or explosives
have been stored.
• do not use the unit if there are
inflammable gases in the air (alcohol,
fly spray, etc.). Turn the unit back
on after having aired the room
sufficiently.
• do not try to repair or modify any
mechanical parts.
• If you notice unusual noises or
suspicious signs, unplug the power
cable immediately and contact your
dealer.
• Unplug the unit when it is not in
use.
• do not use the unit near a fire alarm.
If the outlet air is blowing towards a
fire alarm, the alarm may respond late,
or not at all.
• This unit is only intended for indoor
use in a ventilated area. do not use
outdoors.
