
Natcomm
Page 11
PROGRAMMING NOTES
1)
To program your unit, you need to temporarily connect a standard ANALOGUE
Telephoned (or a Test Phone) to the PROGRAM PORT of your DS4 unit. All
entries must be made using this telephone.
2)
The PBX EXTENSION port of your DS4 unit MUST be connected to a telephone
extension (or you can alternatively use a normal PSTN line). This is so a
telephone line ‘battery feed’ can be connected to the Programming Telephone,
which will allow the attached Phone to generate touch tones.
3)
To enter PROGRAMMING MODE you must turn OFF POWER to your unit and
then switch POWER ON AGAIN.
4)
You must PRESS # within 30 SECONDS of reconnecting power.
You will hear 3 short ‘beeps’ to confirm you are in programming mode.
5)
Individual Parameter Programming Entries (A and/or B) are then carried out by
pressing further keys on the attached telephone (see below).
Notes
1.
Parameters can be changed in any order.
2.
After each entry, DS4 should generate 1 short ‘beep’ to confirm acceptance of
command, or 1 long ‘beep’ to advise of an entry error. If 1 long ‘beep’ is detected,
your command should be repeated.