Rev 8, Dated 27-2-2018
36
5.
Remove the support ply and limit switch.
6.
Remove chain lock and chain (Take help of cycle mechanic if
not possible).
7.
Remove the right and left rack support plate.
8.
Now remove the grub screw and pinion can be removed from
the chassis.
Procedure
9.
Changing of Magnet.
Steps
1.
Switch OFF the machine and remove the front and back cover.
2.
Rotate the flywheel manually so that magnet is in accessible
position.
3.
Loosen the bolts and remove the magnet.
4.
Replace with new magnet.
Procedure
10.
Changing of Limit Switch.
Steps
1.
Switch OFF the machine and remove the 3 pin plug.
2.
Remove the front and back cover to expose the assembly to
the person.
3.
Remove the connection wires from the ACDC drive.
4.
Remove the M 3X 30 Allen bolts to remove the limit switch
from limit switch mounting plate.
5.
Replace the old limit switch with new one.
6.
Use the same old wires for connection if they are not damaged
else use new.
7.
Align the limit switch according to the stopper plate.
8.
Switch ON the treadmill.
9.
Test the limit switch manually, i.e. whether it stops when
touched with finger.
Procedure
11.
Changing of Conveyer Belt.
Steps
1.
Switch OFF the m/c and remove the 3 pin plug.
2.
Mount the 46 L pulley on the front roller.M6 X6 mm grub
screw is being used to fix the 46 L pulley on to the roller by
a key of 8 X 8 X 25 mm.Front roller assembly is prepared and
fitted on to the chassis.
3.
Loosen all 4 mid support angle of the chassis and align them
in one straight line.
4.
OSL board to be kept on the above 4 angle(locating it at 15
mm gap from 46L centering of OSL board with respect
to the chassis).Then make all base points on to the OSL board
through drill of 11mm and a counter sink of 22mm drill.
Dismantle all the 4 support angles by numbering them.
5.
Now take the conveyer belt and roll it on the front roller.
6.
Then roll it on the back roller. After that push the wooden
board inside the conveyer belt and adjust its position
properly.