![background image](http://html1.mh-extra.com/html/narvi/steam-ready-905005/steam-ready-905005_installation-and-instruction-manual_3348997015.webp)
3. CONTROL UNIT AND MAINS SWITCH
- The control unit is installed in the sauna or the dressing room.
- The installation height of the control unit is a maximum of 90 cm and a minimum
of 20 cm from the side of the heater (See image 1)
- Secure the control unit to the wall using screws (2 X 3.5 *15)
- The chord leading to the control unit can be shortened. The chord cannot be inserted
into the connection casing of the heater.
- The main switch is located at the rear, in the upper part of the heater. (See image 2)
4. CONNECTING THE HEATER AND ADJUSTING THE STANDBY POWER
- I/O key (see image 3)
- When the screen is blank, pressing the key will activate the control unit and the
heater. The key must be placed for over a second. The red light will illuminate
- After pressing the key again, the green light will flash. The heater standby temperature
can be adjusted (between 150 and 220 degrees).
- The heater will return to its standby power mode in approximately 5 seconds.
The display will show the stone housing’s temperature.
The standby temperature is adjusted using the +/- keys, when the function in
question is on.
- Long press (<1 second) control unit + heater turned off
5. TURNING ON FULL POWER
- Full power is activated by pressing the function key for approximately a second,
a yellow light will illuminate on the control unit
- Full power is on for two hours at a time, after which the heater returns to its standby
temperature
- Full power can be disengaged by pressing the function key for approximately one
second.
This extinguishes the yellow light and illuminates the red one.
- The Full power temperature and ”power on” time are set at the factory and cannot be
altered by the user.
- The top cover of the heater must not be closed immediately after switching off the
”Full power”. Closing the cover prevents the heat energy, accumulated in the stones,
from escaping, and possibly causing the overheat protection to switch off.
Image 1
min 50
min 20
min 50
min 20
min 50
min 20
min 1000
min 700
max 500
min 20
min
100
min
100
505
605
820
max 900
min 200
max 700
min 30
Image 3
1
2
3
4
5
6
1 yellow
2 red
3 green
4 heater on/off
5 full power
6 standby heat control
Image 2
Main
switch
Return
button
Summary of Contents for STEAM READY 905005
Page 28: ...7 320 Er3 280 2 8 10 15 1 2 2 3 9 5 15 6...
Page 29: ...10 11 12 1 5 3 1 5 13 500 50 100 100 150...
Page 31: ...7 50 7...